Solutions Products Support About Us Find a Distributor Contact Us
Solutions Products Support About Us
Solutions Products Support
TRIM TC 241A
Description Application Guidelines Properties Ordering Information Additional Information
Health and Safety Data Sheet
Brochures
Case Studies
Technical Bulletins
Technical Articles
Tech Tips
Press Releases
Documents
Videos
Logo - TRIM™ wrapped with Metalworking Fluids and Master Fluid Solutions, teal
Logo - TRIM™ wrapped with Metalworking Fluids and Master Fluid Solutions, teal
TRIM™ TC 241A

Antifoam

Description

TRIM TC 241A is a long lasting antifoam that does not contain any of the silicone or poly-siloxane ingredients usually found in antifoam. This unique formula results in much longer functional life when compared to traditional antifoams.

  • Only add to synthetic fluids
  • Use 0.01 (100 PPM) as the add rate
  • Pre-mix in either clean water or coolant working solution
  • Adding a little at a time, “up stream” of the filter helps to ensure maximum effectiveness
  • When properly mixed into the working solution, TRIM TC 241A will pass through filtration down to 2 microns, however, when not properly mixed, it may be filtered out
  • This material is very stable, and when properly mixed, three to four weeks between adds is typical
  • Fluid temperatures must be 21°C or higher at the point of agitation

TRIM™ TC 241A   
©2017-2024 Master Fluid Solutions™